CC2745R10-Q1: How to Scan LE Coded PHY Advertisements Using btool

Itsuki Funabiki

Hi,

I would like to ask about the issue described in the link below.
https://e2e.ti.com/support/wireless-connectivity/bluetooth-group/bluetooth/f/bluetooth-forum/1607297/cc2745r10-q1-how-to-scan-le-coded-phy-advertisements-using-btool/6197314?tisearch=e2e-sitesearch&keymatch=%20user%3A652131#

Was this issue caused by the CC2745 microcontroller on the peripheral side, the central side, or both?
Additionally, has this issue been resolved in the SDK versions listed below?
SDK: simplelink_lowpower_f3_sdk_9_14_02_16

Best regards,

7 months ago

0 Isaac Larson 7 months ago

TI__Genius 10095 points

Hello,

This is most likely caused by BTool. I would recommend using an HCI tester software to work with the host_test firmware.

Thanks,

Isaac

0 Itsuki Funabiki 7 months ago in reply to Isaac Larson

Prodigy 110 points

Hi,

Thank you very much for your response.
Regarding the question in the link below, I recall that you mentioned the issue was caused by a software bug and would be addressed in the next SDK release.
e2e.ti.com/.../6197314

Could you please confirm whether my understanding is correct that the root cause was the BTool included in the SDK?
Additionally, has this BTool bug been resolved in the following SDK version?
SDK: simplelink_lowpower_f3_sdk_9_14_02_16

Best regards,

0 Isaac Larson 7 months ago in reply to Itsuki Funabiki

TI__Genius 10095 points

Hello,

BTool has not been receiving active updates for some time. I highly recommend moving to HCI tester and importing the HCI library for TI devices.

Thanks,
Isaac

Bluetooth®︎

Bluetooth forum

CC2745R10-Q1: How to Scan LE Coded PHY Advertisements Using btool