CC2652P: Which example project in sdk is for MATTER RCP with 3 wire coexistence?

Ryan,

I use 7.10.1.24 sdk, ccs 12.5, example project rcp_CC1352P_2_LAUNCHXL_tirtos7_ticlang.

When I enable coexistence, it shows below.

For 3 wires, how do I enable it?

How do I configure the pins for 3 wires?

It shows many warnings when I build the project. Should I have concern on these warning?

BR,

frank

Coex mode is determined by the SysConfig RF module, where you should enable RF Coexistences using the Coex PHY IEEE 802.15.4

I do not believe you have any need to be concerned about the unused result attribute compiler warnings.

Regards,
Ryan

Ryan,

Can I know which example you use?

I use rcp_CC1352P_2_LAUNCHXL_tirtos7_ticlang in 7.10.1.24 sdk. 

in RF page, it doesn't look like yours.

I need RCP for MATTER. This is correct project, right?

BR,

frank

I'm using the same example as yourself.  You should be navigating to TI DRIVERS -> RF, not RF DESIGN -> RF Design.

Regards,
Ryan

Ryan,

Thanks. I found it.

should I enable below as well? What's the difference with TI DRIVERS -> RF?

BR,

frank

Ryan,

Thanks.

still confuse that what's difference between 2 source for RCP project. Can you help clarify?

RCP example project 

https://github.com/TexasInstruments/ot-ti

BR,

frank

Part Number: CC2652P

Hi Expert, 

My customer needs Thread RCP for matter.

Can I expect that they can pass thread 1.3 certification with TI example code?

RCP example project 

I don't see any test tool like BTool for thread. Customer doesn't need any tool to pass certification?

BR,

frank