CC2652P: CC2652P - ZNP Host interface with ESP32

Hello Bose,

Bosemani Raja said:

CC2352p

-We do not have a CC2352p, did you mean CC2652P or CC1352P?
I do not think we have a esp32 library officially supported. 

If you need Wi-Fi support you could reach out to the Wi-Fi team/thread (similar to the following https://e2e.ti.com/f/1/t/931004/)

We do have plenty of supported z-stack examples on the CC2652R7 and CC2652PSIP, please reference the downloaded SDK in examples for the detailed list. 

Thanks,
Alex F

Hi Bosemani,

You can refer to the Monitor and Test API and reference the Zigbee Linux Gateway host or Zigbee2MQTT solutions for additional guidance, however there are no immediate examples provided by TI for microcontrollers interfacing with a ZNP.

Regards,
Ryan

Hai Alex,

Sorry, Its CC2652P.

Hai Ryan,

I referred these. We are already using cc2652p7 & Zigbee2mqtt in processor-based gateway.

now I'm looking for micro controller solution.

Anyway, Thank you for support.

Hello Bosemani,

Referring your first post above, we do have code examples for UART, which you could implement with ZNP, however you will likely need to figure out how to interface the CC2652P7 with the third-party microcontrollers yourself. 

Thanks,
Alex F

Hai Alex,

   Can you share the link of that example code.

Thank you

Hello Bosemani,

There are two places you can locate the example code, first is in your downloaded SDK through the following path: 

C:\ti\simplelink_cc13xx_cc26xx_sdk_7_10_01_23\examples\rtos\LP_CC2652PSIP\drivers (where you can find uart2callback, and uart2echo project)

or

If you open any projects sysconfig and go to UART2 and find the examples hyperlink which you can open up a local webpage which describes how to setup and use the UART2 driver.

Thanks,
Alex F

https://dev.ti.com/tirex/explore/node?node=A__AFocS9ZEoD-jZKUBiSuc-Q__com.ti.SIMPLELINK_CC13XX_CC26XX_SDK_ZSTACK_MODULE__BSEc4rl__LATEST 

CC1352P-2 LaunchPad examples are binary compatible with the CC2652P.

Regards,
Ryan

Hai Alex,

   I think some miscommunication. I'm not looking for UART example. 

I'm looking for a library to encode & decode the packets for CC2652P7 running ZNP example.

To follow this sequence:  link (ESP32 will be the Host processor)

Regards 

Bose