CCS/CC2530: cc2530 interface with yale lock zigbee - binding done but lock unlock not working

Do you refer to ZCL spec and send lock\/unlock command to Yale Lock?

Hello YK Chen,

                               I had refer ZCL specs for closure but still i dont understand what is problem with lock and unlock in code........please suggest some solution

Can you elaborate what you did to send lock/unlcok command and do you use sniffer to check what happens over the air?

Hello hitesh,

Linking your previous E2E thread here.  Even if the bind request is successful and a bind entry is created on the Coordinator, this does not mean that it was created properly (with proper parameters) or that this will help with controlling the End Device.  You need a sniffer device, IAR debugger, and  known working setup to evaluate and reference, otherwise you will not be able to properly develop this application.

Regards,
Ryan

Hello YK chen,

                 i m sending following command for lock and unlock to yale lock zigbee module,unfortunately i dont have sniffer so i can check response... 

code..........

zclDoorLock_t cmd;

cmd.pPinRfidCode = aiDoorLockPIN;

static bool locked = TRUE;

giDoorLockScreenMode = DOORLOCK_MAINMODE;

if ( locked )
{
zclClosures_SendDoorLockUnlockDoor( SAMPLEDOORLOCKCONTROLLER_ENDPOINT, &zclSampleDoorLockController_DstAddr, &cmd, TRUE, zclSampleDoorLockControllerSeqNum++ );
locked = FALSE;
}
else
{
zclClosures_SendDoorLockLockDoor( SAMPLEDOORLOCKCONTROLLER_ENDPOINT, &zclSampleDoorLockController_DstAddr, &cmd, TRUE, zclSampleDoorLockControllerSeqNum++ );
locked = TRUE;
}

is this any wrong to this code.....

pls help me.....

Thanks in Advance

What's inside your zclSampleDoorLockController_DstAddr? Do you use sniffer to check what happens over the air?

Hello YK chen,

                      I dont have sniffer so i cant check whats inside zclSampleDoorLockController_DstAddr,but my pairing is successfully done with yale lock zigbee module so i think this adress is yale lock adress....or i m wrong.

pls help me to trouble shoot this problem.

thank for your reply

I don't think pairing would give correct content to zclSampleDoorLockController_DstAddr. You might need to assign it by yourself from your coordinator application code.

Hello YK chen,

                        so, how can i find the zclSampleDoorLockController_DstAddr for yale lock zigbee device without sniffer.

thanks for your reply

pls help me...