Part Number: TPS2HB50-Q1 Tool/software:
Hello team ,
I wanted to understand - in the above diagram Vclamp will be activated once it crosses its threshold value during the turn off of inductive load, I assume it is a positive value
but during the…
Part Number: TPS4HC120-Q1 Tool/software: Dear Sir/Madam,
I have been reading the TPS4HC120 datasheet and are a little confused on what protection is required to avoid damage to the TPS4HC120/ microcontroller if the supply or inductive load can get disconnected…
Part Number: OPA615 Using the OPA615 as an SOTA as shown below:
The stability of the circuit seem to be fine and behaves as simulated. I know that the Hold Capacitor is small but this is necessary for the required track time. Increasing the Hold Capacitor…
Part Number: ADS1115 Other Parts Discussed in Thread: TLA2021 , TLA2022 Hi, My customer is requiring us to provide total internal capacitance and inductance of following three ADC to design explosion-proof product. * ADS1115 * TLA2021 * TLA2022 Could…
Part Number: TLC59208F Dear all
Is this an acceptable "misuse" of the part? The coil current of the relay is 11.7 mA, everything should be withing the operating limits of the TLC59208F. Of course the LEDOUT* register will be set to fully ON or fully…
Part Number: SN6505A-Q1 Other Parts Discussed in Thread: SN6505B-Q1
Tool/software:
Hi Expert,
SN6505A-Q1 is used to drive 3:8 transformer to convert 5V to 12V. The load current is 300mA. How to select transformance inductance so that there is…
Part Number: LM5168 Tool/software: Dear team,
I used LM5168 output 5V, when loaded, the inductor will make a whistling sound.
Can you help me see what improvement methods are available?
The circuit diagram is as follows：
Part Number: TPS551892-Q1 Tool/software: Is the inductance 8.2uH appropriate in the figure? According to the data manual, 4.7uH is appropriate in boost mode but 4.7uH is small in buck mode, so I chose 8.2uH.
The design parameters are
input voltage…
hi Pan
pls check below link for how to perform tuning in our DSP.
https://www.ti.com/lit/an/slaa894/slaa894.pdf?ts=1756859005602&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FTAS5805M
thanks
jesse
Part Number: UCC28951
Tool/software:
Vin MIN : 400VDC
VinmAx : 950VDC
Vin ( Typ ) : 600VDC
1. the question is primary magnetizing inductance of a psfb transformer should be selected considering Max input voltage or minimum Input Voltage ? Considering…
