This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ27220: How to calibration BQ27220 with few parameters

Part Number: BQ27220

hi Onyx,

Further question to BQ27220 configuration. my end customer has completed the fuel gauge training and they observed the missing configuration are as follow:

so far, they have managed to write to the design capacity and EDV0,1,2 correctly. Need to know how to write the Calibration parameters: board offset(integer) , CC offset(integer) , CC gain (floating value), CC Delta (floating value) into the register. can you advice the steps? Hope you can provide the clear steps to spped up the troubleshooting. 

Note: End cust do not want to write to OTP but only want to configure the register everytime the MCU boot up to save time and manufacturing process. 

Best Regards,

KPK