Please clarify the below queries -
1. Is it possible to find/estimate the overshoot, undershoot, settling time and number of ringings from the phase and gain plots?
2. How's the magnitude of RAMP voltage is decided in voltage mode control?
loop estimate using transient response.pdfHello,
Yes it is possible to correlate transient response to phase/gain plots.
This attached app note describes how to estimate phase/gain from looking at output transient response.See Figure 5.So it is logical that you could estimate transient response based on phase/gain.
For the ramp voltage, you need as much ramp as possible while staying below the maximum allowed for the IC.The more ramp you have, the more immune to noise, less jitter, the circuit will be.
Ed WalkerTexas Instruments Online Support - Systems & Tools
In reply to EdWalker:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.