Hello,
I want to start sequencer by CNTRL signal.
Is there any way to start sequencer by falling edge of CNTRL signal?
The signal is Low-High-Low. I want to start the sequencer at this High-to-Low edge like the below figure.
Regards,
Oba
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello,
I want to start sequencer by CNTRL signal.
Is there any way to start sequencer by falling edge of CNTRL signal?
The signal is Low-High-Low. I want to start the sequencer at this High-to-Low edge like the below figure.
Regards,
Oba
Hello Yihe,
I know the polarity can be changed.
But as far as I teseted, it is level detection.
It menas it start from Low(1).
Low(1) -- High -- Low(2)
I want to start at High-->Low(2) falling edge. I want to ignore Low(1) period.
Regards,
Oba