• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 30 subscribers
  • Views 837 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

What does a variation of the Response Time (LDC Configuration Parameter) Change?

Frank Benkert
Intellectual 285 points
Other Parts Discussed in Thread: LDC1101

Hello,

the data sheet describes the Response Time Setting as a Setting for a digital filter. Can you please describe what Kind of digital filter this is?

Is it just a change of number of internal samples which are taken for averiging?

Thanks,

Frank 

  • 0
    TI__Genius 14270 points
    Hello Frank,

    With the LDC1000/LDC1101, for a RP measurement, you can view the response time as the number of internal samples used for averaging. For the L measurement, it will correspond to the number of sensor cycles for one measurement.

    Regards,

    ChrisO
  • 0 in reply to Chris Oberhauser66
    Intellectual 285 points

    Hello,

    thanks for your Response, Chris.

    We sense a measurand with high dynamic components, our sensor frequency is running with about 1 MHz, the external LDC clock is 8 MHz.

    Does this mean each LC tank Signal period (fsensor=1MHz) is sampled 8 times (with external clock 8MHz), and this is done x times set with the Response time Setting (192 times to 6144 times) ?

    Taking this into consideration would bring me to the conclusion to use a Response time Setting with Minimum value (=192). That would give me an output data rate of about 10 kHz.

    Correct?

    Thanks, Frank