TDC1000-TDC7200EVM: Both enable and reset needed for spi programming?

Shankaranarayanan P V

Part Number: TDC1000-TDC7200EVM

Hello,

I have interfaced tdc1000 with arduino, where I am facing a shortage of pins. So I had a doubt whether both reset and enable pin are needed for programming the tdc1000 or can I just use enable pin alone for programming and for measurement?

Regards,

Shankar

over 6 years ago

0 Bharat Aravamudhan over 6 years ago

TI__Genius 11015 points

Shankar,

I have received your question, I will review this and respond within a couple of days.

0 rashmi hm over 6 years ago

Intellectual 750 points

Hello shankar ,
You can connect reset to ground and use enable pin for programming and for measurement with tdc1000 chip.and arduino uno pins are sufficient even though you consider both reset and enable pin control using programming.

and what is your application means flow meter or level monitoring.....?

Regards,
Rashmi H M

0 Shankaranarayanan P V over 6 years ago in reply to rashmi hm

Intellectual 270 points

Okay! I will check and see. My applications is for level monitoring.

Sensors

Sensors forum

TDC1000-TDC7200EVM: Both enable and reset needed for spi programming?