Problems connect COM ports using codes in setup.m and main_pplcount_viz.m in Matlab

Omar ELHARROUSS

I'm having some errors while I'm trying to run People Counting code via setup and main_pplcount_viz.m. This is happening when I try to connect to the COM ports. The errors are shown in the following image:

over 5 years ago

0 Akash Gondalia over 5 years ago

TI__Guru 50240 points

Hi Omar,

We'll need more information in order to assist you. Would you post a full error message you are receiving in the console?

You haven't entered a part number, what mmWave device are you using?

Cheers,
Akash

0 Akash Gondalia over 5 years ago in reply to Akash Gondalia

TI__Guru 50240 points

Hi Omar,

Since we haven't heard from you I'm going to close this thread. If you still have questions feel free to post here or open up a new thread!

Cheers,
Akash

Sensors

Sensors forum

Problems connect COM ports using codes in setup.m and main_pplcount_viz.m in Matlab