CC2456MODN GUI for Continuous Rx Test mode

Quang Le55

Hello,

How can I retrieve the Rx information such as BER and other related readings (received good bits, total bits, packets. etc.) in that test mode?

Also what is the relationship between the Continuous Tx and Packet Tx/Rx test modes? Both work almost similarly.

Thanks

over 7 years ago

0 Joseph Gigi over 7 years ago

TI__Guru* 85400 points

Hi,

Please refer to the below pages:

processors.wiki.ti.com/.../CC256x_Testing_Guide
processors.wiki.ti.com/.../CC256x_Production_Line_Testing_Guide
processors.wiki.ti.com/.../CC256x_VS_HCI_Commands

Regards,
Gigi Joseph.

0 Quang Le55 over 7 years ago in reply to Joseph Gigi

Prodigy 80 points

I did but there was no working solution or example whatsoever from those documents. Can you provide a few good working examples such as to set Tx RF output power at about 6dbm with DH3 10101010 longest payload and 500 packets on channel 0 (2402MHz); put the DUT in continuous Tx mode; or continuous Rx mode for BER sensitivity measurement (basically everything needed to measure Tx RF output power and Rx BER sensitivity with actual numbers)?

Thanks

0 Joseph Gigi over 7 years ago in reply to Quang Le55

TI__Guru* 85400 points

Hi,

Can you share the commands (with the parameters) that you tried so I can help you better?

From your description, processors.wiki.ti.com/.../CC256x_VS_HCI_Commands is what you need.

Regards,
Gigi Joseph.

Bluetooth®︎

Bluetooth forum

CC2456MODN GUI for Continuous Rx Test mode