TI E2E Community
Low Power RF Tools Forum
Cc2510 external reference
Hello, somewhere in the data sheet is told that an external reference signal can be applied at CC2510 XOSC-Q1 instead the crystal itself in Q1/Q2.
In this case is there any data about the drive level, and input impedance of the external reference input at Q1?
We are designing a quadruple reader and I would like to drive 4 CC2510 from a single 26 MHz TCXO, because this way I can synchro perfectly the 4 transceivers, otherwise, I would need 4 independent crystals and apart from the sync, maybe this solution can be more sensitive to RF crosstalks. The TCXO device I plan to use delivers 0.8Vpp on a 10Kohm, 10pF load with DC coupling. I would like to know if this device is suitable to drive 4 CC2510 either directly or using 4way small signal distribution
Thanks in advance
See section 9.4 p 34 in the datasheet:)
-- PS. Thank you for clicking Verify Answer if this answered your question!
Please Charlotte in case you are not concerned with this question can you pass this to somebody else. Some changes were decided in this project, one of them is to discard the "powerful" version using the CC2590. All the tags and readers will be based on CC2510 alone. But I wanted to ask you something else, talking with our partners, I suggested that maybe the CC2530 or other members of the chip family are more suitable for an RFID or RF ID/LOC in an interferred environment than the CC2510. But I don't have access to the technical parameters of quality and traffic of our customer to evaluate the needed BER and bitrate. So i just suggested them that DSSS chips like CC2530 can be better because the channel is notably more robust with spread spectrum techniques and CSMA, and if they are using this system to implement some kind of persons or items presence control or data gathering in an open environment where dozens of WiFi or Zigbee or other more robust systems are working i just figured out that the CC2510 is in inferiority, unless they use very wisely the frequency hopping. Certainly, this can be convenient only for high data rate, not to compare the CC2510 at 2.4kbps with the CC2530 at 250kbps. i am not sure because i don't know how much cochannel interference the CC2510 receiver affords, but without FH the system maybe will be blocked below a positive C/I i.e. with interferences lower than the signal. but since Can you give us some idea fof comparison that I can translate to our partners in order to asses them to choose well?
Thank you, in pg. 9.4 the drive level and AC coupling for sinewaves is specified, but th data shet has nothing about CC2510 clock input impedance.
Ould anybody give some data about it?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.