How to add the code from sensor controller studio to my ccs project ?

Zhang

Prodigy 230 points

Other Parts Discussed in Thread: CC2650

I use sensor controller studio write a code about ADC. Then I want to move to my ccs project .

over 8 years ago

0 Christin Lee over 8 years ago

TI__Guru 55895 points

hi,

please take a look at Getting Started Guide, section 5.7 and 5.8.

0 Zhang over 8 years ago in reply to Christin Lee

Prodigy 230 points

hi,Christin!

do you mean this Quick Start Guide?

Regards,

Yue

0 Zhang over 8 years ago in reply to Christin Lee

Prodigy 230 points

or this?

0 Christin Lee over 8 years ago in reply to Zhang

TI__Guru 55895 points

Sorry for not being specific enough, I meant sensor controller studio quick start guide.

0 Zhang over 8 years ago in reply to Christin Lee

Prodigy 230 points

hi,Christin!

Recently，I'm distressed. have you faced with this problem?

i try to run one example code. but i can not connect to sensor controller studio. and also in ccs there is error.

0 Christin Lee over 8 years ago in reply to Zhang

TI__Guru 55895 points

Hi, we have an updated version of sensor controller studio and the whole project works fine for me.

you can find the newest sensor controller studio here:

www.ti.com/.../sensor-controller-studio

what device do you have? which debugger are you using?

0 Zhang over 8 years ago in reply to Christin Lee

Prodigy 230 points

Hi,Christin . i'm so sorry about the late response.

With your help, these days i have successfully tested cc2650 adc module on sensor controller studio. my debugger is XDS100V3.

Now, i want to add this function into SensorTag(RTOS). Then phone can get my senor data through adc and bluetooth.

the question is that i must write a new sensorTaskFxn. what do i need to pay attention to .

Regards,
Yue

0 Christin Lee over 8 years ago in reply to Zhang

TI__Guru 55895 points

You don't have to use a TaskFxn. What do you want to do? Probably you can use it as a HW interrupt?

0 Zhang over 8 years ago in reply to Christin Lee

Prodigy 230 points

Hi，Christin!

i have successfully get my sensor data through ADC. Now my work mainly focused on BLE sensortag(android). While i try to clone from https://git.ti.com/sensortag-20-android

0 Zhang over 8 years ago in reply to Christin Lee

Prodigy 230 points

Hi，Christin!

i have successfully get my sensor data through ADC. Now my work mainly focused on BLE sensortag(android). While i try to clone from https://git.ti.com/sensortag-20-android , something is wrong.

Regards,

Yue

0 Christin Lee over 8 years ago in reply to Zhang

TI__Guru 55895 points

Hi,

I am not sure why git clone does not work for you. I just tried and it works.

But you can just download the source code locally

git.ti.com/.../master
and click download master as tar.gz file

Bluetooth®︎

Bluetooth forum

How to add the code from sensor controller studio to my ccs project ?