• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 16 subscribers
  • Views 544 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CC2650 + XDS100v3

Nicolas MICHEL59
Intellectual 945 points
Other Parts Discussed in Thread: CC2650

Hi,

I want used smartrf06 evaluation board with XDS100v3 to flash my board with CC2650

I have connect

PT 4 of my board  on P409.7

PT 2 of my board  on P409.9

PT 6 of my board  on P409.13

PT 1 of my board  on P409.5

PT 3 of my board  on P409.1

PT 5 of my board  on P409.15

GND of my board  on P409.4

I have try this but it's not OK 2 LEds on Smatrf rf is On Power and Advnced MODE

Can you help me please

  • 0
    TI__Genius 9705 points
    Hi Nicolas,

    I cannot see PT3 on your board in the diagram attached. Assuming that this is connected to supply, can you verify that the supply voltage is correct? You could also verify the activity on JTAG traces using a scope during read/write operation. Also, on the 24MHz xtal, external load capacitors are not needed if the crystal meet the spec from CC2650 datasheet (this will affect the RF operation of the device).

    Regards,