Part Number: AM2432
Tool/software:
Hi,
Customer is asking the following question.
When configured to operate as the " MII " Clock source, the signal does NOT needed to be routed back to the RMII_REF_CLK pin ?
Customer is refering Datasheet…
Other Parts Discussed in Thread: TCA4307 FAQ: Logic and Voltage Translation > IxC >> What is Stuck Bus Recovery?
Stuck Bus Recovery is a mechanism built into an I2C device that automatically attempts to free the SDA bus during a stuck LOW condition…
Part Number: WINCESDK-AM1XOMAPL1X Other Parts Discussed in Thread: DM3730 Tool/software: This is a general FAQ page for questions about WinCE6 on TI devices.
TI does not currently offer Windows CE6 support. By that we mean, if you have any questions…
Part Number: BQ25820EVM Other Parts Discussed in Thread: BQ25820
Tool/software:
Hello all, Here is the BQ25820 Schematic and Layout Checklist: BQ25820_Schematic_And_Layout_Checklist NEW.pdf Best Regards, Christian Moyer
Part Number: BQ25820EVM Other Parts Discussed in Thread: BQ25820 , BQSTUDIO
Tool/software:
Hello,
Here is a link to the BQ25820 BQZ file: https://e2e.ti.com/cfs-file/__key/communityserver-discussions-components-files/196/Charger_5F00_1_5F00_00_2D00_bq25820…
Other Parts Discussed in Thread: TCA9511A
FAQ: Logic and Voltage Translation > IxC >> What Makes an I2C Buffer Hot-Swappable ?
Hot-Swap also known as Hot-Plug means the unpowered device can be inserted into a live backplane without disruption of service…
Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM
Tool/software:
Hi Customer,
This FAQ is about TDA4VM SR2.0 HS Keywriter , there is some change need apply to Default keywriter:
1. Download and Install ti-processor-sdk-rtos-j721e…
Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM
Tool/software:
The following FAQ applies to the DP83869HM and all versions of the DP83867: E/IS/CS/IR/CR
The Analog Supply pins (VDDA2P5 & VDDA1P8) power the MDI portion (connector…
Part Number: C2000WARE
Tool/software:
In some systems, noise on the JTAG pins/traces will result in the debug architecture of the MCU issuing commands that stop the operation of the MCU.
In the following devices, this problem can sometimes be mitigated…