Part Number: MSPM0-SDK Other Parts Discussed in Thread: MSPM0C1104 , MSPM0G3507
Small-package MSPM0 devices often run into hardware UART count limitations due to pin constraints. When you need more serial interfaces than the on-chip UART modules can…
Part Number: LM5180-Q1 Other Parts Discussed in Thread: LM25180 , LM5180 , LM25185 , LM5185 , LM5181 , LM25183 , LM25184
If you are going for PSR Flyback topology for power requirement of 1W to 50W, you can take these LMx518x devices into your design…
Flyback transformers play a crucial role in Flyback topology design, Flyback topology requires coupled inductors with proper turns ratio, better magnetizing inductance and minimum leakage.
Turns Ratio:
Turns ratio must be selected considering recommended…
Other Parts Discussed in Thread: LM5181 , LM25180
For converter parts (LM5181/0, LM25180/3/4), to calculate maximum output power, you can use these formulae:
POWER DELIVERY CURVES
Pout vs Vin for all variants on same graph at different turns ratio…
Snubber circuits are designed to suppress voltage spikes, limit the rate of voltage and current changes, and protect switching devices from damage.
It is recommended to use snubber circuits across SW and Vin, and across Flyback diode. Refer this technical…
Part Number: LM5180-Q1
Flyback transformer
To operate as flyback converter, transformer polarity has to be as expected, reversing polarity makes the converter work as forward converter which cannot provide expected output when loaded. Also, check…
RSET resistor is used to set the internal 1.21-V reference to the input of the error amplifier for internal closed loop. RSET is recommended to keep at 12.1 Kohm to maintain 100uA current in RFB and RSET resistors, and vary RFB to obtain required output…
Select a Schottky diode for this application to account for inevitable diode voltage overshoot and ringing related to the resonance of transformer leakage inductance and diode parasitic capacitance. Connect an appropriate RC snubber circuit (for example…
Other Parts Discussed in Thread: LM25184 Connect a diode-Zener clamp circuit across the primary winding to limit the peak switch voltage after MOSFET turnoff.
We recommend using a Zener diode with a clamp voltage of ~1.5x the reflected output voltage…
