Frequent Questions

  • [FAQ] TAS Devices Information

    Other Parts Discussed in Thread: TAS5103 , TAS5706 , TAS5706B , TAS5142 , TAS5342 , TAS3308 , TAS5611 , TAS5613 , TAS5342LA , TAS5342A , TAS5342L , TAS5404Q1EVM , TAS5614 , TAS5558 , TAS5538 , TAS5615 , TAS5630 , TAS5630PHD2EVM , TAS5704 , TAS5602 , TAS5707…

  • [FAQ] Linux/AWR1642BOOST: ROS Development and Customization

    Part Number: AWR1642BOOST Other Parts Discussed in Thread: AWR1642 Tool/software: Linux Hello, I have completed the ROS demo using the 2.0.0.4 SDK on the AWR1642BOOST. The unit is flashed with the Demo binary file from the SDK. I was working…

  • [FAQ] What are the best cross reference replacement for the MCP6001, MCP6002, and MCP6004 devices?

    Other Parts Discussed in Thread: TLV9064 , TLV9004 , TLV9001 , TLV9062 , TLV9061 , TLV9002 Hello, I need to identify replacement op amps for the MCP6001, MCP6002, and MCP6004 devices. What are the best replacement amplifiers from TI? Thanks!

  • [FAQ] LM2904: What are the best op amps for low cost designs?

    Part Number: LM2904 Hello, Could you help with the selection of op amps for low cost or cost-optimized circuit designs? Thanks!

  • [FAQ] MSP430F6779: Interfacing EMDC with another MCU over UART

    Part Number: MSP430F6779 Other Parts Discussed in Thread: MSP-FET Hello, Is there any help available on interfacing EMDC with another MCU over UART.

  • [FAQ] TINA/Spice/TINA-TI: TINA-TI floating point error while using capacitors

    Hi all, Thanks for the reply, it worked last time but now i cant figure out why the attached circuit cant be simulated and it shows some error which i cant figure out. it shows a node error between c1 and c2. please do let me know if there are any …

  • [FAQ] TLV320AIC3254: Re-burning the programmer, not recognized

    Part Number: TLV320AIC3254 Hi Team, I used the tlv320aic3254evm-m evaluation board to test it. During the test, I burned the internal program. Then I couldn't identify the evaluation board. I didn't know what happened after a long day of tossing.…

  • [FAQ] How can I verify my Power over Ethernet (PoE) equipment is inter-operable? Is there a "Logo" program?

    I would like an easy way to be sure that my Power over Ethernet (PoE) equipment is inter-operable. I want to avoid the potential issues outlined in the TI blog linked here -->

  • [FAQ] OPT3101: Any question concerning general range/accuracy of OPT3101

    Part Number: OPT3101 For the following questions please refer to the answer below. What is the measurement accuracy? How long can you measure from the shortest to the longest? Is output accuracy different depending on the distance? Is output…

  • [FAQ] Please watch UCD Sequencer Training Portal https://training.ti.com/fusion-digital-power-designer

    Hello UCD90xxx Sequencer Training portal is online. please go to below link to learn how to use Fusion Digital Power Designer Tool to configure. https://training.ti.com/fusion-digital-power-designer Regards Yihe

View FAQ threads