Part Number: ADC128S102QML-SP Tool/software: Hello TI Engineering,
I would like to request the neutron displacement damage test report for the ADC128S102QML-SP please. We are in the process of verifying radiation requirements compliance. Thank you.
…
Part Number: ADC128S102 Tool/software: Hi,
We are presently planning to use ADC128S102QML-SP in a new design using 1MHz clock frequency (minimum clock frequency for this device is specified as 800KHz). For early breadbording stages, we were planning to…
Part Number: ADC128S102QML-SP Other Parts Discussed in Thread: ADC128S102 Tool/software: I'd like to find out if there is a maximum rise/fall time for the digital inputs. For a 16MHz sinusoidal clock, the 20/80 rise time would be about 12.8ns, so I'd…
Part Number: ADC128S102QML-SP Tool/software: I have looked through the datasheet for the above part but cannot find the material of the metal beneath the soldermask.
Would you please provide this information? I would like to be able to look up the thermal…
Part Number: ADC128S102QML-SP Tool/software: 1)
Does note 3, under 6.1, mean that vin can exceed the absolute maximum voltage of VA + .300 or go below -.300V provided the pin current is limited to less than +-10mA and total current less than +/-20ma…
Part Number: ADC128S102QML-SP Tool/software: Hello.
I am considering using a pull-down resistor to fix the /CS pin to low level. Will there be any problems with using it?
If there are no problems, how many ohms of pull-down resistor would be good? Please…
Part Number: ADC128S102QML-SP Tool/software: Hi, in a few words I would like to use the ADC in a lower resolution mode.
From the datasheet I understand that a frame is delimited by CS but also that it must be 16 clock cycles long:
"A serial frame is…
Part Number: ADC128S102-SEP Other Parts Discussed in Thread: ADC128S102QML-SP , Hello,
I would like to know if this component is the same chip with respect to ADC128S102QML-SP but with different package and screening or if they are different chips.
Thank…