Part Number: ADS5287 Other Parts Discussed in Thread: ADS5294 , ADS5282 , ADS5281
Dear expert:
when we use ADS5287 test mode for SINGLE_CUSTOM_PAT to output all 0 customer pattern. It will have some different data at the output for some times. could you…
Hello,
I have read in the page 16 of the ADS5281 datasheet ( http://www.ti.com/lit/ds/symlink/ads5281.pdf ) That "after power-up, the internal registers must be initialized to the respective default values".
I wonder if using the Evaluation Board…
Hi,
The user guide for this EVM was probably written back when the TSW1200 was the commonly available capture card, but now we support that EVM with the TSW1400. one difference that I suspect might be hindering you is that the TSW1200 had FPGA firmware…
Hi,
The AFE5805 is supported by the Medical Group, and as such any firmware for the TSW1405 for the AFE5805 would have to come from that group. So I am moving this posting to that forum. I do note that the sample data format for the AFE5805 is very similar…
Eli,
when you say non-related to a specific design, I am guessing that our source code for the LVDS parallel bus format would be best suited. The source code defines inputs to the FPGA for all the possible LVDS pairs that are listed in the schematics…
Hi, Jim-san
I thank you for your support.
In previous circuit I was using the ADS5281 and THS4521.
This time, it plans to use the ADC3222 and THS4521.
(Transe and THS4541 was NG at a cost)
In differential in THS4521 single-ended analog signal, enter the…
Other Parts Discussed in Thread: ADS5282EVM , ADS5282 , ADS5281 Hi, does anyone know how to use ADC SPI interface on windows 7 64 bits to initialize the ADS5282EVM? I spend two days on how to install the driver for this evm board, searched over this website…
Other Parts Discussed in Thread: ADS5282EVM , ADS5281EVM , ADS5281 , ADS5295 Hi to all community,
I'm a newbie in fpga developement and i've confused beacuse i need some skills for my project and i'm not sure about my decision.I would use a Xilinx…
Hi, Richard.
I did all procedures posted here.
But still our EVM (ADS5281) got out of device manager list on my desktop.
Anyway, we ordered a new same EVM.
Here is a test setup list.
1. Power up ADC EVM with 5 V supply and its ground.
2. Connect the…
