Part Number: AFE4410 Hi ti team,
Currently, we are working on 25HZ green light data acquisition based on AFE4410 for application to HR algorithms. Please help to provide the corresponding configuration table parameters. Thank you so much!
Part Number: AFE4410 Hi ti team,
Could you please provide the manual for the attached document?
AFE4410_Timing_Calculator_Partron_Insync_GUI_low c.xlsx
Part Number: AFE4410 Dear TI Engineer,
We plan to use AFE4410 on our wearable products, with the following design:
Power supply: RX_SUP=+3V; TX-SUP=+5V; IO_SUP=1.9V (same as external MCU).
Communication: I2C, I2C_SPI_SEL is connected to a low level …
Part Number: AFE4410 Hello! I would like to request the technical documentation for AFE4410 as below.
AFE4410 data sheet including registers descriptions.
AFE4410 application notes
Thank you very much!
Simon Chan
Part Number: AFE4410 Hello TI Team,
I am reaching out to inquire about obtaining a reference schematic design for the AFE4410.
I am currently working on a collage project that requires the use of this device, and having a reliable reference schematic…
Part Number: AFE4410 I'm from Anker Innovation Company. Currently, our product is using your AFE4410 heart rate monitoring board. At present, we are encountering a lot of noise issues in the PPG signal. We have tried to adjust the current gain and…
Part Number: AFE4410 Hello, We are using AFE4410 IC in one of our projects.We are facing some issues in SPI.We are getting 0 register value when try to read any register through SPI.As per the data sheet,before reading register, we have set/reset following…
Part Number: AFE4410 Hello,
We have an issue concerning AFE4410 and SPI communication. It is described in attachment. It may be necessary to add, that we used two SPI clock speeds - 1 Mhz and 500 kHz.
Best regards,
afe_issue.pdf
Part Number: AFE4410 Hello,
I am here caught up in fetching multiple PD data from your device. I appreciate the support and cooperation that you have offered. The addresses you mentioned earlier (2Ah to 2Dh) store the data for each of the four phases…