Part Number: AFE7070 Hello
I would like to know if there is any way to take a look at the Generated Baseband Signal of the AFE7070. We use the integrated NCO and would like to have a look at the time domain of the baseband signal.
If I don't apply…
Part Number: AFE7070 Tool/software: Hello
I have a strange behavior when using the Digital Interface Bits, when I set the MSB D13 RF Power drops significantly.
Is it possible that the Chip interprets this Pin as sign?
Phillip
Part Number: AFE7070 Hi
What is the recommended termination of the LVDS Output Pins (44 and 45) if the LVDS function of the chip is unused? Can they be left open or should they be connected to GND?
Is it allowed to not supply the LVDS Power Pin…
Part Number: AFE7070 Other Parts Discussed in Thread: AFE7071 , Hi
I would like to know whether AFE7071/AFE7070 can support below 30MHz rather than 100MHz depending on the specification RF frequency range.
What is the limit for AFE7070 when operated…
Part Number: AFE7070 Hello
Does anybody know what would be the fastest frequency change rate of the NCO?
If I change the frequency tune word, will I see a change in frequency on the next DAC sample or is there any delay I have to consider?
Is…
Part Number: AFE7070 Hi, I am planning to develop modulated transmitter for telemetry purposes.
The current goal is to provide both frequency modulation and phase modulation from the same hardware depending on the type of modulation selected by user…
Part Number: AFE7070 I have a situation where I need to burst data into an AFE7070 from a microcontroller. I'm hoping to use Dual Input Clock Mode so that I can make use of the FIFO.
A few questions:
1. So long as I throttle using the alarm_SDO pin…
Part Number: AFE7070 Sorry for a newbie question:
I want to use an AFE7070 to generate a 4FSK signal.
Can do that by just varying the IQ data? If so, how? If not, how can I?
Thanks
Other Parts Discussed in Thread: AFE7070 Hi,
I want to work with the AFE7070 in "Dual input clock(00)" mode. I have configured register0 value to 0xB6 or 0xB4, and there is no RF output, When I change the "data_clk_sel" to '1', it start work( their…
