Part Number: AFE7444 Hi ,
We are testing the AFE7444 with Ultrascale FPGA.
We noticed every time we change the Waveform we need to reset the DAC.
Can you know to tell us how can we fix it. or the reason behind it?
With regards,
Ganesh Singh
Part Number: AFE7444 Hi
i am able to find the sleep mode for all 4 dac.
Please let me know How can put all the ADC in sleep mode individually. like ADC A or ADC B or ADC C or ADC D any one from it in sleep mode.
With regards,
Ganesh
Part Number: AFE7444 HI ,
I am in the process of implementing the JESDIP on the Custom board with 10 Gbps rate.
I noticed in the TI JESDIP there is requirement of two clocks.
1. MGT clock .
2. SYS clock
We don't have two clock from same source in our…
Part Number: AFE7444 Other Parts Discussed in Thread: AFE7686 , I want to use DAC Jesd mode (L_M_F_S_HD 1TX = 22210x24 HBW).
The datasheet says that the mode (22210x24 HBW ) is available, but "Register Programming for JESD and Interpolation Mode" doesn…
Part Number: AFE7444 Hi ,
In one of our custom Board, RF loopback is not passing, Cna you tell me how to debug this?
TX NCO tone can be seen out of DAC. PLL is also locked.
With Regards,
Ganesh
Part Number: AFE7444 Hi, I work with AFE 7444. I have a problem with reading power detector register values.
For read register value I use addresses from this table:
For power detector initialization I use this procedure from your example:
Problem that…
Part Number: AFE7444 Hi ,
I am not able to find the
"AFE7444 Register Set Technical Reference Manual" specified in data sheet.
If you have it, please forward to me
Let me know what is this manual.
With regards,
Ganesh
Part Number: AFE7444 Other Parts Discussed in Thread: AFE7686 Hi,
I am testing a board for a TI AFE7444 transceiver for a new project. I am using DAC Jeds mode (L_M_F_S_HD 1TX = 22210x24 HBW).
The AFE7444 transceiver operates normally after initial setup…
Hi Yeonyeol,
This question is answered in the following post: https://e2e.ti.com/support/rf-microwave-group/rf-microwave/f/rf-microwave-forum/1073145/afe7444-afe7444-prgorammer-guide-register-set-document-question
Regards,
David Chaparro
Hi Yeonyeol,
I have responded to your question on the other post.
https://e2e.ti.com/support/rf-microwave-group/rf-microwave/f/rf-microwave-forum/1074403/afe7444-struggle-in-correct-set-start-up-e-fuse-shift-section
Regards,
David Chaparro