Other Parts Discussed in Thread: MSP-FET Hello,
I think this must be a very simple question, but I am new to the uTCA concept and also to the C6678 EVM.
I have followed this older post: http://e2e.ti.com/support/dsp/c6000_multi-core_dsps/f/639/t…
Hi,
I wanted to share some test code that I did for myself, maybe someone else can find it interesting as well.
It is based on StarterWare v2.00.00.07 and was tested via JTAG emulator and run directly in DDR.
There is a ReadMe.txt in the attached…
Hi
I am trying to test out my SRIO code on C6472 EVMs and need a board to connect them (i.e. AMC to AMC connector). Has anyone come across a product like this?
FYI. I came across this while searching: Altera has a connector for TI EVM to Altera…
Hi Srinivasa,
What is your application? What does your signal chain look like? I think the calculations in this current sensing EVM user's guide may be useful to reference Section 4.1.3:
AMC-AMP-50A-EVM Evaluation board | TI.com
Best regards…
Part Number: AMC1300 Other Parts Discussed in Thread: AMC-AMP-50A-EVM
Tool/software:
Hi team,
When AMC1300 is used in solar inverter phase current sensing, the SiC MOSFET is TO247-4 package, pls check below questions:
1. Should INN pin be connected…
Hi Sapana,
425Arms with a 500uOhm shunt is 90.3W, which for many applications is beyond tolerable heat dissipation. I would expect most applications to instead use a smaller value shunt, perhaps 50uOhm which would then pair nicely with the 50mV input…
Hi Ashik,
Thank you for your question. Yes, the AMC13xx device family can sense DC current. You can use only the positive input range of the device if that's all your application senses. For high currents up to 40A I would recommend the AMC1302 over…
Part Number: TPS546E25EVM-1PH Other Parts Discussed in Thread: TPS546E25 Tool/software: Hi Team,
I am using TPS546E25 EVM in LAB. When i try to load current more then 1.2V@30A from E-Load. I can see in GUI Monitor TAB Current Graph Start toggling…
Part Number: TPS48111Q1EVM Tool/software: Hi team,
Could you please help clarify why the calculation tool fails the SOA when using the EVM's MOSFET specifications? If your calculation results can pass, please send me your results.
My design is below…
Hi Archin,
I would suggest to start from 50A per phase.
In general, you need to:
Send SYNC signals to each phase with proper phase shift
Send the primary IC voltage loop error signal (ERRLV) to ISETx of all IC.
Please refer to LM5171 EVM…
