Part Number: BQ24091
Hi, TI expert
Customer is reviewing BQ24901, and there is a recommendation for a vendor and part number for NTC.
In the datasheet of BQ24091, there is the following information.
Even if you search for 10-k NTC and from the…
Part Number: BQ24091 Other Parts Discussed in Thread: BQ24090
Hi, TI expert.
According to the BQ24091 datasheet, I understood that using ß=3370 out of 100K NTC would allow setting from 0 to 45°C without additional external resistors.
However, after…
Part Number: BQ24091 Hi,
I want to use BQ24091 to charge 3.7v 2500mAh lithium ion battery. My queries are:
1.In Datasheet BQ24091 out voltage is 4.2. Can i use 4.2 OUT voltage output to charge 3.7V battery placed in J11 connector place. by using…
Part Number: BQ24091 Dear，
We layout a board to test BQ24091 and meet some problem.
When we set pin7 ISET2 to High, sometimes there is no Low status output in P8 CHG during chagring stage.
If we set Pon7 float, the status of P8 is ok.
And we…
Part Number: BQ24091 Hello,
In two of our projects we are using the BQ24091 to charge a 80mA lipo battery but for some reason it doesn't react like expected.
I have set the Riset resistor to 10k7 in order to have 50mA of fast current.
I have ordered…
Part Number: BQ24091 Hi,
Is it possible to connect an NTC to the TS pin and to the MCU at the same time?
In that way, I could use the NTC to detect when there is a problem when charging the battery and when the device is used I could monitor the…
Part Number: BQ24091 Hello,
When I set Iinmax = 1A, Ichg = 1A but Vin source connected to Note PC (Iinmax = 500mA)
1. Can I use Fast Charge (1A charging)? or charge current is limited only 500mA?
2. If Battery pulled 1A by force, It can make Host…
What is VBAT? It is ok to have the pull up from PG to OUT, however PG pin should not be pulled low when there's no input power connected.
Thanks,
Wenjia
Other Parts Discussed in Thread: BQ24091 My app uses BQ24091 to charger for Lithium battery from 5V DC power. when battery discharge down to about 1.5V, the IC does not charge. is there any way to fix this?
if this is function of BQ24091 please show…
