Part Number: BQ24250 Hi Team,
The customer had the question about the STAT pin behavior, according to the DS description below:
Status Output. STAT is an open-drain output that signals charging status and fault interrupts. STAT pulls low during charging…
Part Number: BQ24250 I have soldered on the following charging circuit onto a printed circuit board. I followed the datasheet and determined that these were the proper components. I asked in an earlier question concerning how to configure En1, En2, SDA…
Part Number: BQ24250 Hi everyone,
I am issuing some problems in developing a board with the IC reported, expecially in the evaluation of the on/off charge status.
I will try to explain the flow-chart in detail, and please, let me understand if I do something…
Part Number: BQ24250 Hi,
I am using battery charger circuit using BQ24250 for one of the project.
After applying 5V input at input pin of charger IC getting output voltage after 10-15sec at VSYS.
Also if we are remove input from the chrager IC and giving…
Part Number: BQ24250 Hi,
I received some devices of these devices built in 2016 and wanted to know if there was any risk with these parts in terms of solderability or any other factors due to the age. Can you also point me to any shelf life guides for…
Part Number: BQ24250 Other Parts Discussed in Thread: BQ25616 , BQ25619 Hi team,
Do we have a Pin to Pin socket for BQ24250RGER? The current limit can be selected and the can be maximum current must be larger than 1A.
Many thanks!
Jayden Li
Part Number: BQ24250 Hello, I'm currently working on a charging project. The circuit is designed to have an input of 5V and charge a Li-Po battery (3.9V and 2200mAh). The goal of this circuit is to be able to have a charge current around 2A. So i've chosen…
Part Number: BQ24250 Hello,
I am working on a BQ24250 application to power a 1S 2200mAh LiPo battery. I'm having issues with the current delivered to the battery which seems to be too weak, both when controlled in I2C or in standalone mode (the charging…
