Part Number: BQ25611D Tool/software: Hi,
In the datasheet '9.3.3.3.1 D+/D– Detection Sets Input Current Limit', it says
If an adapter is detected as unknown, the input current limit is set at 0.5 A by ILIM pin.
Where is the ‘ILIM' pin?…
Part Number: BQ25611D Tool/software: hi,
I have some question for BQ25611D.
1.
If VIN(USB or adaptor) is not plug in , and the voltage of VSYS is higher than BAT pin, Will it have current flowing into the battery through the POWER PATH?
2.
If VBUS and…
Part Number: BQ25611DEVM Tool/software: Hi Ti, Does the OTG function of the BQ25611D-EVM only support OTG when it is in high mode, or can it support both OTG and USB charging simultaneously?
Part Number: BQ25611D Hi Expert,
My customer is using BQ25611D, and they find in 2 pcs prototype, bq25611d will power reset immediately after QON pin pull low, and others can well power reset after the so called tQON_RST(minimum 8s). They also replace…
Part Number: BQ25611D Tool/software: Dear TI Engineer,
We found that BQ25611D did not enter a constant current charging state when testing its charging curve, and the battery voltage was also fluctuating. The battery capacity is 1500mAh, and the power…
Part Number: DRV2625EVM-MINI Other Parts Discussed in Thread: BQ25611D , DRV2625 , Tool/software: Hi Ti, We are using the following battery gauging module BQ27421-G1B EVM along with a charger module BQ25611d EVM , and it’s all interfaced with ARM processor…
Part Number: BQ25611D Other Parts Discussed in Thread: BQ25620 Tool/software: Hi Team,
Could you suggest an alternative solution for BQ25611D with TS function disable/enable function?
Thanks,
William
Part Number: BQ27421EVM-G1B Tool/software: Hi TI, I’m using the BQ27421-G1B-EVM board for gauging purposes and BQ25611D-EVM for charging the battery. According to the data sheet, I confirmed that the BQ27421-G1B-EVM is programmed with CHEMI_ID…
