Part Number: DAC70501 Hi,
i was wondering whether I can interface a DAC70501 using I2C when the I2C bus is at 3.3V (and pulled-up to 3.3V) while VDD of the DAC70501 is at 5V.
Obviously I want to save having to use level converters and according to…
Part Number: DAC70501 Other Parts Discussed in Thread: DAC70502 Hi at all,
I am implementing now the DAC70501Z and DAC70502 devices in my software project. Reading the config register of both devices after reset deliver a 0x0200, that means bit 9 is…
Part Number: DAC80501 Other Parts Discussed in Thread: DAC70501 Tool/software: Hi Team,
The DAC80501 output voltage is abnormal if the input data changes the MSB!
Use the internal Vref.(2.5V)
For example, if the input is 0x3FFF and the DAC output…
Part Number: DAC70504 Other Parts Discussed in Thread: DAC70501 Tool/software: There are 4 DAC (DAC70504) outputs, but I only use 1 and the other 3 are not used. What should I do with the unused pins?
Part Number: DAC7631 Other Parts Discussed in Thread: DAC70501 , DAC63701 , DAC53701 , DAC7551 Hi, I'm Rama Krishna form Schneider Electric.
Currently we are using DAC, MAX535BEUA+T (8-uMAX/uSOP package)from Analog devices, now we are looking for FFF…
Part Number: TMS320F28376S Other Parts Discussed in Thread: DAC70501 Hi Expert,
My customer now is target to design a ANC (Active Noise Cancellation) system, and they are searching our ADC / DAC or MSU based total solution, need expert to provide the…
Part Number: TMS320F28027F Other Parts Discussed in Thread: DAC70501 Hi everyone,
I having problems to configure the SPI 3-wire mode, to simply send 3 bytes to an SPI slave.
The GPIOs are correctly configured:
SysCtrlRegs.PCLKCR0.bit.SPIAENCLK …
Hi,
Apologies for the lack of clarity in datasheet regarding this.
First send the command byte (bit 23 to bit 16) then the data bits (bit 15 to bit 0).The DAC data is left-aligned, so the 16-bit device of course uses all of the lower two bytes but…
Hi Vladimir,
We current do not sell a current-output DAC that can operate at that high of a current. We have a new product in development, but you will probably see that available in about 6 months.
I recommend that you look at this reference design…
