Part Number: DAC80508 Hello team,
We need your help to solve a trouble for getting the output on the device.
We're in trouble as listed below.
- When wriiing 0x7FFF to DAC0-DAC7 on register, the output level remains at 0V.
- There is no change in the…
Part Number: DAC80508 Dear friend,
My customer test the chip REF directly which just set the CS low and high. The register setting is default and used the internal reference.
They placed 1uF capacitor between REF and GND.
Here is CS low. Ref voltage is…
Part Number: DAC80508EVM The 80508EVM is connected to USB2ANY.
USB2ANY Explore works ( I done update with USB2ANY hardware ) .
Next, I run the DAC80508 Software. It is in demo mode. I try initialize, but it fails.
Please, give me advice.
Part Number: DAC80508 Hello,
I am a bit confused about calculating the total noise from the DAC Outputs. Specifically I don't understand this table
(Can be found on page 8 of the datasheet)
I think it is first telling the noise over the bandwidth…
Other Parts Discussed in Thread: USB2ANY , DAC80508 Good morning
I am trying to use the USB2ANY with the DAC80508EVB.
When starting with the DAC80508 software the 3V is not available. I think it is needed by the EVB
If I start the USB2ANY utility I can…
Part Number: DAC80508 Hai,
In my design, I have used QSPI to communicate with DAC80508MRTET. Currently, MISO is not getting properly. Is there any particular steps to be followed to configure communication with DAC via QSPI
Part Number: DAC80508 Hello, Let me confirm about below. * According to datasheet, TI defined several drift parameters (Offset error drift, Zero-code error drift and so on.) Then I would like you to confirm about below for there drift parameters. Q. Is there…
Part Number: DAC80508
Hi, I would like to confirm my doubt about the design issue. Does the SPPI MISO pin have to be pulled?
Currently, I CAN'T get any response from 80508 SDO, but DAC outputs CAN be controlled correctly by measuring the channel outputs…