Part Number: BQ41Z90 Other Parts Discussed in Thread: BQSTUDIO Tool/software: Hello. I want to use the REGOUT of BQ41Z90, but I can't find anything to control the REGOUT in the Technical reference(attached file) and bqstudio. Datasheet(atteched file)…
Hi Chris,
here is some material for you. Do you know the datasheet of (obsolete) OPA660? And this appnote?
opa660.pdf
01b7cd566115c542b887f956a5e2af638d2f.pdf
And you might find this thread useful. It contains some TINA-TI simulations with the…
Part Number: TMDSHVPSFBKIT Hi,
I had found the datasheet of the pin description for PR798 from one of the TI forum queries. But pin number 7 is grounded in the datasheet of PR798 whereas supply voltage is provided to the same pin in the reference design…
Part Number: TMS320C6748 Tool/software: Code Composer Studio Good day,
We are customized design using C6748.
we are facing (Error-6311) PRSC module failed to write to a register.
(Emulation package 5.1.450.0)
Please find the attached Schematic…
Hello Richards,
Thank you very much for your suggestion. I have performed many LEARNING CYCLE. Although the first few times I successfully reduced the SOC from 14 to 10, the FCC also dropped significantly to 7230mAh. Unfortunately, after that, the learning…
Xavier,
Can you check to make sure that Device Mode in the ZCG is set to MAC Mode(see page 21 in the attached). This needs to be done to operate on PRIME protocol.
Best,
Matthew tidu237.pdf
Hi Bob, Yes, you are correct. In my circuit, VCC is 3.3V, and there is a 2.048V reference that is in the input circuit. So the max voltage is less than2.048V. Maybe I will do not use ADS122c04 since its max sample rate is 2Ksps. In my circuit, there is…
Other Parts Discussed in Thread: ADS8168 , ADS8028 , ADS114S08 , ADS1119 , ADS1118 , ADS7042 , ADS122C04 Hi team,
Now I want to find a replacement for LTC1867L which is ADI company device. The datasheet of LTC1867L is in the attach. It is 16bit and…
Part Number: UCD3138PSFBEVM-027 Hello, is the main circuit on the UCD3138PSFBEVM-027 development board using a diode-clamped advanced phase-shifted full bridge?
Some documents say that the loss of the lagging type is smaller, why do you choose the leading…
