Part Number: DEM-OPA-SO-2A
Tool/software:
Hi TI team,
Thank you for your support.
1. Is this board ROHS3 Directive (EU) 2015/863 compliant?
2. If so, Can you provide RoHS certification for this part?
Kind Regards,
Takashi
T47285…
Part Number: DEM-OPA-SO-1A FOR EVAL BOARD : DEM-OPA-SO-1A, WE REQUIRED BOM TO BE POPULATED ON THE PCB WITH SCHEMATICS, ASSEMBLY INSTRUCTIONS AND TESTING PROCEDURE AS PER DATA SHEET.
Part Number: DEM-BUF-SO-1A Hi Team,
A customer has this board but they are having 10x attenuated output and not unity gain.
The board was assembled as per the schematic with the corresponding value:
Rin1 = 50 ohms; Rin2 = 25 ohms; Rout 1= 50 ohms;…
Ahmed,
What sensor are you using and what is the expected current output signal?
With the large transimpedance gain (1Mohm) and large sensor capacitance of 185nF, the bandwidth will not be very wide, maybe on the order of 10kHz. You are using the…
Paul, The best way to evaluate the VCA821 is to purchase one of our unpopulated evaluation modules (EVMs). This one costs only $5 for an unpopulated PCB.
-Samir
Hi Frank,
At light load or no load the regulator goes into DEM (Diode emulation mode) behavior. This helps to improve efficiency. So, the mode you're looking for is DEM. If you need low ripple at no load or light load choose an inductance with ripple…
Hi Onkar, Thanks for the response. I have updated the output capacitance to 47uf and still the IC is not regulated to 16V output? with same design. I have some points while checking schematic 1. SYNC pin is short to GND so, it working in DEM mode 2. PG1…
