Part Number: DLP5530PGUQ1EVM Hello -
I want to know the corresponding parameters of DRM_MODE about 1152x576_60hz.
DRM_MODE is defined as follows：
Thanks，
yang
Part Number: DLP5530PGUQ1EVM Hello -
What should be paid attention to when the EVM connects to the HDMI of the embedded development board.
When the EVM that can extend the PC is connected to my embedded development board, I can't run the program of the…
Part Number: DLP5530PGUQ1EVM Other Parts Discussed in Thread: DLP5530PROJQ1EVM Hello -
In DLP5530PGUQ1EVM Evaluation Module User's Guide, I saw that the throwing distance of the optical module is 70mm.But it seems a little small for us.
Is there any…
Part Number: DLP5530PGUQ1EVM Hello Ross,
I have tried selecting "External vedio port" as source with 1152x576. But we got the following error " source error 674.(External source parallel port pixel clock frequency is not within the allowable…
Part Number: DLP5530PGUQ1EVM Hello -
Regarding the firmware given in the figure below, will it cause the system to enter an interrupt?
After I burned the firmware, the red light in the image below came on. The system entered an interrupt and the EVM…
Part Number: DLP5530PGUQ1EVM Dear Expert ,
Good day!
Our customer want to confirm the EVM Optical Module Specifications , the Throw ratio and Throw distance is fix or adjustable ?
From the picture of EVM , it seems like can be adjust , so could you tell…
Part Number: DLP5530PGUQ1EVM Other Parts Discussed in Thread: DLPC230-Q1 , TPS99000 Hi
I have procured a DLP 5530 EVK Kit
I have gone through the schematic and understood that the HDMI interface is done to DLPC is through chip TVP401, which is a HDMI to…
Hi,
This will be a response to the following e2e chain as well.
https://e2e.ti.com/support/dlp-products-group/dlp/f/dlp-products-forum/1072858/dlp5530pguq1evm-reply-to-dlp5530pguq1evm-cannot-activate-display-mode
The main issue customer was seeing was…
Part Number: DLP5530PGUQ1EVM Other Parts Discussed in Thread: DLP5530Q1EVM We want to understand DLP5530 firmware for our future design.
Could you please help to share the required firmware with us?
