Part Number: DRV8874-Q1 Tool/software: Dear team.
Do we have Pin FMEA report of DRV8874-Q1? They found short between pin11 and pin12, and need to know the failure mode of this.
Best regards, Yuto
Part Number: DRV8874-Q1 Other Parts Discussed in Thread: DRV8874 Tool/software: Hi team,
could you help provide the maximum value(IOCP,TOCP,TRETRY)? and what is maximum current of internal mosfet
Part Number: DRV8874-Q1 Other Parts Discussed in Thread: DRV8874 , , DRV8873-Q1 Tool/software: Dears:
customer found when change nSLEEP status, will trig fault pull down.
Picture one is nSLEEP from low to high, then fault pull down.
Picture two is nSLEEP…
Part Number: DRV8874-Q1 Other Parts Discussed in Thread: DRV8242-Q1 Hello Team,
customer see leakage current sinking into OUT pins even when tri-state.
Is there a specification available for this current?
Background: There is a supercap storage behind…
Part Number: DRV8874-Q1 Other Parts Discussed in Thread: DRV8874 Hello Team, one question from customer:
Is the charge pump active when OUT1 and OUT2 are tri-state (means in-acitvie) ?
Many Thanks
Josef
Part Number: DRV8874-Q1 Other Parts Discussed in Thread: DRV8874 Baed on the model DRV8874 PSpice Transient Simulation (Rev. A): www.ti.com/.../slvmcx0 - The device configuration: PMODE = 0 and IMODE = 0;
- Load connected between OUT 1 and OUT 2 (full bridge…
Part Number: DRV8874-Q1 No.1
Is the VM line affected by motor surge from the motor connected to the OUT1 and OUT2 terminals? If so please tell me what to do.
No.2（Related to question No.1）
Could you tell me the CBulk capacitance value of the VM line in…
Part Number: DRV8874-Q1 Other Parts Discussed in Thread: DRV8874 , DRV8243-Q1 , , DRV8873-Q1 I'm having a problem using the DRV8874 with a 775 DC Brushed motor, which recommends a startup current of 10A.
Setup: PMODE grounded (PH/EN mode), IMODE Grounded…
Part Number: DRV8874-Q1 Hi, Technical resposible!
the technical specification of our application can be classified with this consumption range (IOUT < 0.4 A and 5.5 V ≤ VVM ≤ 37 V).
Could you confirm how I calculate the Analog current output…
Part Number: DRV8874-Q1 No.1：Function mode switching
Active mode ⇔ sleep mode, switching control Is it possible to switch modes when PMODE is set to Hi (PWM control mode) and IN1 and IN2 are connected to nSLEEP? (Normally, the IN1 and IN2 terminals…
