wolfgang spiess said: As we discussed about the kind of PWM-Signal we forgot about our main problem . Our only problem is not the PWM-Signal itself. the problem is the needed Signal at nSleep -Pin on "power up".
Hi,
Can you confirm the waveform…
Part Number: DRV8876N Other Parts Discussed in Thread: DRV8876 , Hi,
I was using a DRV8876 (the non-N version) in a design and recently decided to switch to the DRV8876N, as it was far more common.
When making the switch I read the datasheets and couldn…
Part Number: DRV8876N Hello;
I've set up a circuit using the DRV8876N Motor Driver, but upon testing have found that the chip is not operating and the fault indicator is showing a fault condition.
According to the data sheet, the fault indicator will…
Part Number: DRV8876N Hi team, I'd like to know about the size of via. My customer wants to change to via size φ0.3 from φ0.2. Please let me know if there is any problem to change via size? Sincerely. Kengo.
Part Number: DRV8876N Hi Sir,
Would you pls help question as below? Thanks.
About the H Bridge the Vvm of drv8876n as below figure.
Customer request VM need to from 0V.
Please help to find the proper part. Control Pin IN1/IN2/nFault are must.
Thanks…
Part Number: DRV8876N Hi team,
My customer only have 12V PWM input in their system, do you have any advice if we need to use DRV8876N?
Or maybe you have another device that could support 12V logic input?
Thanks！
James
Part Number: DRV8876 Hi all
I have a question about DRV8876 and DRV8876.
What is the difference between DRV8876 and DRV8876N?
I understand that the DRV8876 has an IPROPI pin. Also, The DRV8876 has Current Sensing. Are there any other differences?
Best Regards…
Hey Dan,
As a software solution for using DRV8251A, could you try inputting a very short pulse of at least 1us (or as short as you can make it, as long as it is >1 us) in between consecutive input pulses? This should have minimal effect on the output…
Hi Wolf,
This is a duplicate question. Here is the link to the other thread where I will be supporting you: https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/1233792/drv8876n-ph-en-control-mode-setting-won-t-work
Regards…
Part Number: DRV8876 Other Parts Discussed in Thread: , DRV8220 , DRV8870 I apologize if this is not the right page for this question, but I couldn't find a relevant forum for my topic.
I am tasked to redesign my current VFD filament driver that has…
