Part Number: DRV8906-Q1
All bit fields of "OP_CTRL_3" and "FW_CTRL_2" are Reserved. What action does the driver take when sending an instruction to write data of "0x00" to "OP_CTRL_3" and "FW_CTRL_2"?
添付資料をご参照ください。
Part Number: DRV8906-Q1 Hi team,
"11.1 Layout Guidelines" has "PGND" and "AGND" explanation. Could you tell me which GND is "AGND" and which is "PGND2 shown in "11.2 Layout Example"?
Regards, Ochi
Part Number: DRV8906-Q1 Hi team,
(1) What is load condition shown in table Table 8-12?
(2) Does it have recommended nFAULT current range? We will use 10mA sinc current to nFAULT by using 5V supply and 500ohm pull up resistor, is it no problem?
Regards…
Part Number: DRV8906-Q1 Hi Team,
I got the following question from a customer:
What happens exactly in the case of a resistive short circuit between two outputs when one output is on low and the other on high? Is the current limited within the time…
Part Number: DRV8906-Q1 Hi Expert,
Our customer use DRV8906-Q1 and they want some software demo programming for reference. Do we have related code or register configuration? Thanks.
BR,
Elec Cheng
Part Number: DRV8906-Q1 Hi Team,
My customer had the following question:
If a single output is loaded, the driver switches off in the worst case at 1.3A.
In the worst case, how much current can the driver drive at least before switching off if you…
Part Number: DRV8906-Q1 Hello team,
What is the meaning of OT(yellow highlighted area)? Over-Temp Warning(OTW) or Over-Temp Shutdown?
And below yellow highlighted portion seems typo. Correct comment is below red comment, right?
Please correct…
Part Number: DRV8906-Q1 Dear Team,
I have a prototype board using the TI DRV8906-Q1 grouping 2 x 3 channels in parallel. While the datasheet says " The over-current protection (OCP) ensures the device protection in any short scenarios like the phase…
Part Number: DRV8906-Q1 Other Parts Discussed in Thread: DRV8908-Q1 Hello team,
Regarding DRV89xx-Q1, 0.1uF cap and >1uF cap is recommended to add at the VDD pin.
However, 1uF is not populated at the VDD in the EVM.
What is the recommendation…
Part Number: DRV8906-Q1 Hello team,
Regarding DRV89xx-Q1 family, the minimum abs max of VM pin is 4.5V and this must be incorrect.(4.5V should be recommended operating conditions.)
What is the correct value of the minimum side of the abs max of the…
