Part Number: DS110DF410 Hi Team
In my system i have two Retimers of DS110DF410 located at two different systems as can be seen in the following diagram
System A which is the Primary drives three channels while system B drives a single channel…
Part Number: DS110DF410 Hello, My customer would like to use DS110DF410 at 10G ethernet (10Gbps).
What eye diagram specifications does DS110DF410 data input have to meet? Best regards, K.Hirano
Part Number: DS110DF410 Tool/software: Hi,
we are using DS110DF410 as pass through IC for ARINC818 data in which link speed is 1.0625Gbps ,we want to use same hardware for HD-SDI ,in which speed is 1.48Gbps ,is it possible to use DS110DF410 for HD…
Part Number: DS110DF410 Hi expert,
We'd like to double check that:
What requirements that we must follow except 100 PPM and 2.5V clock level.
Although it appears that there aren’t any stringent phase/noise requirements on data sheet.
Thanka…
Part Number: DS110DF410 Hello,
At my customer, under their evaluations, if they start I2C access 17ms after power up, they can not complete register programming correctly. But, if they start I2C access 25ms after power up, they can complete register…
Part Number: DS110DF410 Hello,
At my customer, under their evaluations, if they start I2C access 17ms after power up, they can not complete register programming correctly. But, if they start I2C access 25ms after power up, they can complete register…
Part Number: DS110DF410 Tool/software: Hello, My customer would like their host to communicate with slave DS110DF410 vis PMBus and has some questions as follows. Q1: About the PMBUS communication (Write/Read) format of the DS110DF410SQ, he assumes that…
Part Number: DS110DF410 Tool/software: Dear TI Technical Support:
Does the 25MHz supplied to refclk_in need to be synchronized with the Data?
Would it be okay to supply it from an external crystal?
Part Number: DS110DF410 Tool/software: Hi team,
I have some questions regarding the pin settings.
1) When using the DS110DF410 with the CDR bypassed, is it necessary to input a reference clock? In that case, can the REFCLK_IN/OUT pins be left open…
Part Number: DS110DF410 Tool/software: We are planning our initial hardware checkout of a new circuit board that uses the DS110DF410SQE/NOPB and would like to know if we need our software team to program this device after power-up in order for the device…
