Part Number: INA194 Hi Team,
I will need your support to do a schematic review for failure analysis on PN INA194AIDBVR.
L1 - 6.5 – 9 uH, DC Resistance 3.5mOhm
R36 - 5.6 Kohm, 0.1 W
C36 - 1 nF, 50 V
TH1 - 220 Kohm, 210 mW
C22 - 470 nF, 16 VD…
Part Number: INA194 Hi Team,
my customer has started a new design with INA194AIDBVTG4, could you please confirm that the device will no be intended to obsolesce for the 5 years ahead?
Thanks and regards,
Shai
Part Number: INA194 hi team,
could you please confirm the INA194 max input voltage on Vin pin?
datasheet claims as below:
I'm confused with the Analog inputs range: -18~18V. if the chip can deal with 80V common mode, the analog voltage on Vin should…
Part Number: INA194 I am trying to provide a valid P/N for the INA194 current shunt monitor. When I check a distributor's stock I get many variations on this theme:
INA194AIDBVR
INA194AIDBVRG4
INA194AIDBVT
INA194AIDBVTG4
INA194AQDBVRQ1
Most manufacturers…
Part Number: SN74LVC1G175 Other Parts Discussed in Thread: INA194
[Case:711493]Technical Data Inquiry for our customer.
1- Regarding each of the following parts:
TPS3808G01DBVTG LM5050MK-1 SN74LVC1G175DCK
-- Please help us know if each part is affected by…
Part Number: INA194 Other Parts Discussed in Thread: INA282 , INA213 Hi Team,
I have a customer who is using the INA194 and had a question about the operation of the INA194 in the Low VSense mode as specified on page 19 of the datasheet.
In the case when…
Other Parts Discussed in Thread: INA194 , LMP8640HV I have a prototype board that uses an INA194 (SOT-23-5) to measure current from a high side shunt.
Shunt - 0.012 ohms
Current range - 0 - 5 Amps (0 - 60mV)
Common mode voltage - 200mV to 48v (typical…
Other Parts Discussed in Thread: INA194 Hello,
My customer uses the INA194, monitoring a current of 24V supply line.
V+ is 5V, a external comparator trip level is 0.7V.
Power up sequence is as follows.
1. V+ = 5V ON
2. 24V supply line ON
According to the…
Other Parts Discussed in Thread: INA194 Hi Team,
INA194 seems to be a high side current shunt device. However, can you use it as a low side current shunt monitor ?
I can find the description on the product page, but, no description in the datasheet.
If…
Other Parts Discussed in Thread: INA194 , INA210 , INA213 I have five high side inductive current monitor circuits each driving hydraulic solenoids. The INA194 is used to measure the current and the inductive flyback. The specs are: 0.62 ohms sense resistor…
