Part Number: INA210 Hi TI team,
We are using a current sense IC ( INA210CIDCKT) in our design. We have seen multiple failures of these parts while testing, and wanted to understand what could be a possible failure mode of these parts when the input pins…
Part Number: INA210 Hi team,
My customer would like to check is INA210 circuit stable or not, so they would like to do real measurement.
So could you provide guideline for customer to measure it?
I saw there is " Closed-Loop Analysis of Load-Induced…
Part Number: INA210 Other Parts Discussed in Thread: TINA-TI Hi Ti,
We use the INA210 for current measurement ranging from 0.1 mA to 0.9 mA.
The circuit diagram is as shown below.
We have observed a 25 kHz oscillation at the output terminal (PSEQ_MON_VP12P0_MB_AMP1_ST…
Part Number: INA210 Dear Support,
We are using the current-sense amplifiers INA210BIDCKR for output current monitor.
But it has some failed issue when working, analysis found that the pin4(IN+) and pin5(IN-) are shorted with GND.
In order to find the…
Part Number: INA210 Other Parts Discussed in Thread: UCD90320 ,
1. Do you have equation for calculating Rshunt value ?
2. We are using UCD90320 Amon pin for ADC converting. Therefore, Ineed to choose Iout Cal Gain and Iout Cal Offset in fusion desgin tool…
Part Number: INA210 Hi Team,
I noticed that the HBM ESD rating of INA21xA was changed from 4kV to 2kV(from revision I to revision J), may I know the reason behind this?
Regards,
Charles
Part Number: INA210 Hi Team,
The customer report that when they remove the voltage on V+, but keep 20V on the IN+/-. There is a leakage voltage on the output pin.
I had done the same test condition on the EVM. The behavior can also be duplicated on the…
Part Number: INA210 Hi Team,
My customer is going to use INA210CIDCKR as the second sockets of INA210CQDCKRQ1, do you have any comments? it can be seen form the datasheet that the Operating supply voltage(Vs) of INA210CIDCKR is 5V, but for INA210CQDCKRQ1 it…
Part Number: INA210 Other Parts Discussed in Thread: INA190 Hi,
Good Day. I have a customer who is working with current sense amplifier. Please see below the two queries of the customer for your reference. Thank you very much.
******************** ***…
Part Number: INA210 Other Parts Discussed in Thread: INA181 I am designing a current sensing application on a solar PV line. The line voltage will be around 1500V DC. Since we are planning to measure the current on the low side
1. Can the current sense…