Part Number: ISO7731 Tool/software: Dear SIR:
May I have some question regarding TI some document mention ISO7731?
as below link page 4 Figure 5 circuit have mention BAS40 on pin 5 and D2 between pin 12 and 13
https://www.ti.com/lit/an/slyt403a…
Part Number: ISO7731-Q1 Tool/software: Hello team,
1. Are there any specific input transition rise/fall rate requirement (From Low to High, and From High to Low) for these ISO77xx-Q1 family?
2.Are there any risk that device get damage if the above…
Part Number: ISO7731
Hi team,
My customer found a issue about ISO7731DWR, could you please help review and give some suggestions? Thank you.
The problem is the waveform on the output side OUTC(5pin) and the input side are inconsistent, with a large…
Part Number: ISO7731 Other Parts Discussed in Thread: ISO6731 , ISO7831 The creepage distances of ISO7731 and ISO6731 Only 8mm, it cannot meet customer demand that is 11.5mm creepage distances, so I would like to ask if there is an isolation plan that…
Part Number: ISO7731-Q1 Other Parts Discussed in Thread: ISO7731 In the application I'm working on, I would like to enable the digital isolator using a soft start (RC) pin the controller on the primary side. For this I would be interested in the enable…
Part Number: ISO7731 Hi,
I am trying to use the circuit provided on the PDF entitled "Designing a reinforced isolated I2C bus interface by using digital isolators" but am unable to get it working. I have built the "Final isolator circuit" shown in…
