Part Number: LDC1612 Hi Team,
For a short-range LD1612 based target detection sensor, where the target would be a 3 mm diameter x 1 mm thick copper metal surface that would never be any further than ~1 mm away from the coil, where this coil would be…
Part Number: LDC1612
Tool/software:
Hallo, we are trying to measure the distance from 0mm to 2mm with a small wire wound coil to a Steel plate made out of S235JR. technically we can live with good readings between 500um and 1500um but having a mmonolitic…
Part Number: LDC1612 Tool/software: Ti Team
Recently, our customer has shown interest in eddy current sensors. Their requirement is a sensing range of 2.8mm to 6.0mm. The target approaches the coil axially, with the target material being manganese-chromium…
Part Number: LDC1612 Tool/software: Hi Team,
Customer wants to design an inductive proximity sensor with the following requirements:
Sensing range: 120 mm
Max PCB width: 50 mm
Sensing resolution: 10 mm (should give around 100mv for 10 mm movement…
Part Number: LDC1612 Tool/software: Hi All,
I'm trying to calculate the sampling rate of the LDC1612 in one-channel mode. To do this, I first used the LDC131x/LDC161x Configuration Tool (also known as the Inductive Sensing Design Calculator Tool ),…
Part Number: LDC1612-Q1 Tool/software: Hi team,
My customer Denso is looking for automotive inductive sensing solution to detect object/human proximity for in-cabin radiant heater. If anything is close to the heater it will turn heater off to prevent…
Part Number: LDC1612 Hello.
There are several questions when using LDC1612 to measure the height of different areas on coils and metal planes:
There is a soft magnetic sticker under my metal plane to be measured, which is used to fix the metal plate…
Part Number: LDC1612 Tool/software: To whom it may concern,
I have a question about the calculation formula of the digitized sensor measurement.
According to formula 4 in the data sheet, DATAx is expressed by the following formula:
DATAx = fsensor…
