Part Number: AM3351
hi,
i am using DDR3 of MT41K512M16HA-125ATR for my custom board .
i am attaching Datasheet of DDR3 MT41K512M16HA-125ATR:
MT41K512M16.pdf
According to EMIF tool it is generated Below timings and i modified board.c file according…
Hi Wyatt,
Thanks for looking into the issue.
- We had referred to the application note mentioned in the ticket for the lead-acid battery and also TRM. But still, we did not get clarification of the above parameters and that is why is choose to post…
Other Parts Discussed in Thread: ENERGIA Hello,
I am a postgrad engineering student who would like to use the MSP432 for a wsn network. I have the MSP-432P401R launchpad and am running Linux Mint. I have installed CCS as per the instructions and installed…
Bernard, I have gone through the spreadsheet and made a few tweaks for component reuse from the old design. Can you check over my version (based on yours) and make sure that I haven't gone off the rails?
UCC28704 design.xlsx
I did have a question…
Part Number: AFE7444EVM Other Parts Discussed in Thread: AFE7444 I have read through all the user manuals and application notes for the AFE7444EVM to place it in Rx-Tx loopback mode. I found the attached configuration file which I found by searching other…
Other Parts Discussed in Thread: TVP5158 We compile the algorithm code in the CCS 3.3 and select optimize -O2 to product the static lib:face.lib
Then we link it to the dvsdk codec_engine project, the link operation is fine,
but try to execute…
Hi Danny,
Please see my replies below.
Danny Peng said: 2.The same frequency oscillation appears on both the system and the EVM. Base on your experience, Is there any possible relation between them?
3.Is requirement of PM>45 deg and GM <-8dB defined…
Hi,
thank you for the reply. Is that really so?
We use the scilinREG "SCI2 module (LIN in SCI mode)" in order to be able to fine tune the baud rate. According the launchpad users guide the pins of this module are not muxed. (See Attachment p. 7, p9…
Other Parts Discussed in Thread: SYSBIOS I recently added the UART module to my RTOS AP. Now I get warnings when I compile my AP. Please see the warning messages below. I followed the suggestion and added the TIRTOS.useUART to my .cfg file, but it continues…
