Part Number: LM10502 Other Parts Discussed in Thread: TPS62821 , TLV62568 Hi Team,
Please kindly provide the Buck1 and Buck2 efficiency curve at VIN 5V, VOUT 3V. Like Figure2,3 of data sheet.
We focus on the light load 10mA~35mA. Customer require…
Other Parts Discussed in Thread: LM10502 Hi,
We are designing in a LM01502 device but I see no mention of the SPI electrical parameters on the LM10502 datasheet outside of SPI max frequency of 10MHz. We are running a SPI interface of only 38KHz and…
Other Parts Discussed in Thread: LM10502 Hi,
I set up jumpers according to LM10502 EVM User's Guide, and connected USB cable to a PC. a "Yellow LED" turned on. I thought I am supposed to see a "Green LED" and a "Yellow LED". Aslo, when I started LM10502…
Other Parts Discussed in Thread: LM10502 Hi,
Reading the datasheet for the LM10502, it makes no mention of which SPI Mode is supported. Can you tell me which SPI mode is used by the LM10502?
Other Parts Discussed in Thread: LM10502 HI there,
We did a little bit more test. Again, according to the LM10502 EVM User's guide,..
When the USB board is plugged in for the first time, the operating system prompts for "New hardware found" and installs…
Hi Jeff,
We do not have an exact match for these specific output voltages under these specifications.
Closest match may be:
LM10502 :
Dual Buck (+ LDO)
SPI - Programmable Vout Values
VIN: 3 V - 5.5 V
2.5 x 2.5 mm, 0.5 mm pitch
Best…
Pragash,
For your input voltage requirement - I believe www.ti.com/.../lm26484 may fit your requirements. This is very close to the example parts you mentioned above.
As for your other questions -
1) Yes, you are right, we do not have a wide support…
