Part Number: LM25061 Hi Team,
We are now penetrate our LM25061 in my customer side, and now I have one question want to check with you. If customer don't want to use the PGD function, can they leave the FB pin float? If not, how to do with it? Thanks…
Other Parts Discussed in Thread: LM25061 , LM5069 , CSD16415Q5 , LM25069 Is it possible to design LM25061 for high current 25-30A limit shutoff with 10A average current.
Other Parts Discussed in Thread: LM25061 Hello team,
Our customer Inspur/Langchao are using LM25061-2 in many server projects, and their end customer Alibaba asked them add once RC in the gate control pin, pls refer to the schematic about the parameters…
Part Number: LM25061 Hi,
On few boards, LM25061 is showing low impedance b/w pin 1(Sense) and pin 2(Vin).
On failing samples with initial analysis following things are found:
Impedance b/w pin 1 & 2 of failing samples is in range of 2 to 5ohm…
Hi
The fault timer time seemed longer than calculated time when customer tested the output short test.
Please see the waveform below.
Fault Timer Time at CT=0.22uF is 4.7ms. But it was 20ms.
What does the time depends on. Can you give some advice…
Hi Lakshmi,
We do not have the thermal information of the LM25061 specifically. However, we do have the thermal information for the LM5069 which is similar and also in a VSSOP package:
So you can use the LM5069 thermal coefficients as a rough…
The TPS247xx series only provides CL/Pwr limit at power up. After that it is a threshold based timed shutdown (circuit breaker). Look at the LM25061 that will have a current limiter with timeout and see if it works for you. It will provide a set CL during…
Other Parts Discussed in Thread: LM25056 , LM25061 , LM25066 Hi,
Is it possible to power the I2C bus so it can be accessed before the 12 V (input) is applied?
Thanks,
Adrian
