Part Number: LM25145 Other Parts Discussed in Thread: LM5146 , LM5145 Tool/software: Team, I hope you are well.
The calculation Excel sheet for this device is missing here : LM25145DESIGN-CALC Calculation tool | TI.com
Could you please provide the file…
Part Number: LM25145DESIGN-CALC Other Parts Discussed in Thread: LM25145 Dear Sir,
I am currently using LM25145 to design a buck circuit for a circuit board. When I do design verification, I found the EN/UVLO function has some issue. I used 100kohm as RUV1…
Part Number: LM25145DESIGN-CALC Other Parts Discussed in Thread: LM25145 Hi support team,
I want to reproduce the calculation with Webench, but I can't. Please tell me how to reproduce with the condition of the attached file
Regards, Seiso LM25145_7.5V…
Part Number: LM25145DESIGN-CALC Other Parts Discussed in Thread: LM25145 Hi support team,
What is the difference between Diode Emulation Mode ON and OFF? I think Diode Emulation Mode ON is more efficient than Diode Emulation Mode OFF at light loads. But…
Part Number: LM25145DESIGN-CALC I want to adjust detailed spec on snvc207C, could you tell me the password for unprotecting?
※Tools ⇒ Protection ⇒ Unprotected Sheet ⇒ password: ???
Best regards,
Satoshi
Winnie,
From a first look your schematic looks good.
Maybe the MOSFET only being 3mm x 3mm might get thermally warm, consider the power loss and heat management of those components.
Please double check your component values with the quickstart calculator…
Hi SHH,
Can you fill out LM25145DESIGN-CALC?
I am unable to open that attachment, can you re-upload zip file to E2E or email me at o-murray@ti.com?
-Orlando
Hi Emanuele,
At first glance this looks like compensation instability.
Can you fill out a LM25145DESIGN-CALC with your values and attach it here?
If it is not the compensation values then it may be layout related.
Let me know,
-Orlando
Hi Emmanuel,
Can you send over your filled out LM25145DESIGN-CALC as well as the layout?
Also the SW node waveform would be very useful.
I think your schematic might be ok as it starts up to 12V, but there is definitely some instability I think is layout…
I also was given the suggestion of recommending a few newer-generation devices that may be better suited for load sharing application, in implementation and in improved device performance.
Please see suggested device and their corresponding quickstart…