Part Number: LM2766 Tool/software: Hi there!! As I have no previous experience with switching voltage converter ICs, I'd like to ask if there are any special precautions to be taken in order to power hifi audio equipment.
I plan to use a 10uF/10v MLCC…
Part Number: LM2766 Can this part be capable of charging an output cap of 4700uF? Charging time is not an issue as long as it is below 1 minute or so. During the charging time, output cap will not be subjected to any external load except the capacitor…
Part Number: LM2766 If low ESR/high capacity output capacitors are used, is there a limit? We are a bit concerned of the high in-rush current when the charge pump starts. Is 50µF ok?
Part Number: LM2766 Hello Team,
My customer is going to use our LM2766.
Data sheet recommends MBR0520LT1. However his board space is limited and hope to use smaller one.
Can we recommend other smaller equivalent diode in combination with LM2766…
Hi Brigitte,
yes, I had read that data sheet section, but I hoped the very small current I use could give me a chance of removing the diode.
I will go for option 2.
Thanks and regards,
Stefano
Part Number: LM2766 Other Parts Discussed in Thread: LM2765 , , LM2665 , MAX660 The popular MAX660, and one of TI's derivative, LM2665, could also be used as voltage splitter. A "Splitting Vin in Half" circuit is illustrated in the section 10.3 of MAX660…
Part Number: LM2766 Hi E2E Team
I am not familiar with ANSI standards, so it’s hard for me to understand the symbols C1 and C2 on page 1.
if I look at the designation, this is a non-polar capacitor ( ANSI Y32.2-1975 , p.44), but by the description…
Part Number: LM2766 Hallo E2E Team, The LM2766 says that it needs a diode between Vin and Vout to protect the device from turning on its own parasitic diode and potentially latching up. Unfortunately, the datasheet does not show, where this parasitic…
Other Parts Discussed in Thread: LM2766 Hello,
May I know if LM2766 SD pin can achieve PWM backlight control?
Secondly is it the best suitable part for below mentioned requirement?
Vin = 3.3V Vout = 4V Iout max = 30mA
Thanks,
joy
