Search tips
Showing 28 results View by: Thread Post Sort by

  • LM3526: LM3526H

    TI Thinks Resolved
    Part Number: LM3526 Hello TI support. I picked out LM3526H for over currents/in-rush currents protection on one of the USB channels configured as host port in my application. Second USB port is configured as a client port. In the "Description" section…

  • Question of LM3526

    TI Thinks Resolved
    Other Parts Discussed in Thread: LM3526 We have a question about LM3526. (LM3526MX-H/NOPB) In datasheet p.10 Figure.22 Self-Powered Hub Per-Port Voltage Drop, "Tantalum or 100µF electrolytic, per port" 33µF is tantalum and 100µF is ceramic…
    • Answered

  • LM3526: Connection of pins

    Resolved
    Part Number: LM3526 Hello everyone, This is my first post in TI commumity. So please forgive me if my question is not properly explained, but i will try my best. I have a mcu (FT905L), i want to usb connection with overcurrent protection LM3526 but…
    • Resolved
    • Answered

  • LM3526: 0.01uF Ceramic Capacitor for EMI

    Resolved
    Part Number: LM3526 Hi, There is mentioned in LM3526 data sheet that "A 0.01uF ceramic capacitor is recommended on each port directly between the Vbus and ground pins to prevent EMI damage". However, 0.1uF ceramic capacitors are used in the typical…
    • Resolved
    • Answered

  • LM3526: Difference between LM3526MX-H/NOPB and LM3526MX-L/NOPB

    Resolved
    Part Number: LM3526 Hi E2E, What is the difference between LM3526MX-H/NOPB and LM3526MX-L/NOPB? Based on the packaging information on the datasheet, both parts is the same, is there any other difference in this part numbers? Thanks for your help.…
    • Resolved

  • LM3526: part marking code

    Part Number: LM3526 I NEED HELP IN DICIPHERING THE FOLLOWING MARKINGS TO OBTAIN THE DATE CODE: 53HN 3526 M-L AND ..... 72KC 3526 M-L
    • Answered

  • LM3526-H EN pin

    Resolved
    Does LM3526-H ENB pin have internal pull down? Our customer use only channel A side. In this case, should they connect ENB to GND? Best Regards, Kohei Sasaki
    • Resolved
    • Answered

  • Question about LM3526

    Resolved
    Other Parts Discussed in Thread: LM3526 Hi I am using lm3526 for a usb controller. I am not sure about the meaning of two parameters listed in the datasheet (page 3). One is "Isc Short Circuit Output Current", another is "OCthresh Over-current Threshold…
    • Resolved

  • RE: USB Host for Flash Drive. (Tivaware)

    Hello Amit, We use a Texas LM3526 as an USB Power Switch, controlled by USB0EPEN (PB6) and read by USB0PFLT (PB7). This should work, right? Thank you, Leonardo

  • AM335x USB Host detection

    Other Parts Discussed in Thread: LM3526 On my board i have connected USB0 as a Host. ID pin is connected directly to ground, USB0_DRVVBUS is driven enable pin of 5V power IC (LM3526M-H). USB0_VBUS is connected to the switsching Power of LM3526M-H. My…

Didn't find what you are looking for? Post a new question.