Part Number: LM36274 Tool/software: Hi Sir,
Our customer want to use LM3t6274 to flash their TFT LCD panel by using LM36274 with 60Hz frequency for around 10 sec. Is it possible to control it by setting 0x08's BL_EN bit or any other suggestion? Thanks…
Part Number: LM36274 Tool/software: So, I migrated from a 2-channel device to this 4-channel device. I need to drive 2 LEDs in series, with approximately 6-6.5 being the forward voltage. Will this LED driver be able to drive the LEDs as the datasheet…
Part Number: LM36274 Other Parts Discussed in Thread: LP8556 , TPS65132 Hello,
We have a problem in LM36274 debugging.
The LM36274 can work well when PWM disabled.
But the LM36274 does not work when the 75HZ PWM signal is input.
So we would like…
Part Number: LM36274 Tool/software:
LM36274 Min I2C CLK freq for LM36274 is 1MHz? Only found fast mode spec min 1MHz in the datasheet.
Our design's I2C frequency now is standard mode 100KHz, LM36274 can support I2C 100KHz?
Part Number: LM36274 Hi Sirs,
Regarding the internal block diagram of LM36274 shown below, can components 1 and 2 highlighted in the red box be adjusted through Register or other means?
If not, are there any other TI ICs with similar characteristics…
Part Number: LM36274 Hi，
1.If there is issue on CLK，does LM36274 have mechanism to recover itself？
2. Will LM36274 pull SDA low to trigger CLK timeout issue？
Thanks
BRs
Given
Part Number: LM36274 Other Parts Discussed in Thread: LM3642 Hi Team,
just want to check on what's the difference between below two parameters? what does it means " device not switching pass mode" ? Thanks.
BRs
Given
Part Number: LM36274 Hi Team,
here is a question on auto-switching frequency operation.
During actual test, we find that
a. when the 8-bit MSB < = Low threshold, Fsw changes to 250kHz.
b. when low threshold < the 8-bit MSB <= high threshold…
Part Number: LM36274 Hi team,
In LM36274 there is an function called active discharge. I want to know its behavior when it is enabled. When the device switches to shutdown mode, will this function enable for a long time? Or it is just used in switching…
