Part Number: LM5164-Q1 Hi sir,
We are using LM5164-Q1 converter for step down application from 48 to 7V.
While applying load transient at output load from 0 to 200mA the ripple voltage shown inverse behavior during transient.
In the above image green…
Part Number: LM5164-Q1 Other Parts Discussed in Thread: LM5164 , TPS53353 , TPS53355 Hi sir,
we are using LM5164 converter for step down operation with input supply 48-54V.
This converter driving 1mA load with 173khz frequency in diode emulation mode operation…
Part Number: LM5164-Q1 Other Parts Discussed in Thread: LM5146-Q1 , LM5146 Dear team,
My customer is studying our functional safety document, and they have some questions as below,
LM5164-Q1:
If the voltage of VIN is higher than absolute maximum…
Part Number: LM5164-Q1 How can I get the safety manual for LM5164-Q1?
https://www.ti.com/lit/ds/symlink/lm5164.pdf?ts=1649329537606&ref_url=https%253A%252F%252Fwww.google.com%252F
Thank you,
Al Makke
Part Number: LM5164-Q1 Hi,
Please see below schematic which am using with components as given in it.
Please see Waveform at no Load and 10mA Load, both are same.
M unable to understand reason for such ripples.
Thanks
Rohit
Thanks
Rohit
Part Number: LM5164-Q1 Other Parts Discussed in Thread: LM5164 Dear TI Expert,
We are using the LM5164-Q1 for converting 48V to 12.0V. Our operating range is 30-60V. Output current is 750mA (approximately) in NORMAL mode.
DCDC parameters: L = 68uH RON=…
Part Number: LM5164-Q1 Other Parts Discussed in Thread: LM5164 Hello experts,
I have question about current limit and IC behavior when current limit function is broken. 1. Could you tell me maximum output current before current limit working? Is it 1.25A…
Part Number: LM5164-Q1 Other Parts Discussed in Thread: LM5164 Hello,
I have an application that may have place LM5164's in parallel. They would sit on separate boards connected by wire (coax). The total load should not exceed the capability of a single…
Part Number: LM5164-Q1 Other Parts Discussed in Thread: LM5164 Hi,
I am using Lm5164 for generating 12v, and my actual load to it at output side is 30mAmps only.
So while getting calculations done on webbench, shall I do designing as per 1amp load or 30mAmp…
Part Number: LM5164-Q1 Hi TI,
When LM5164-Q1 is disabled (EN = LOW), the IC shutdown current is a good low 6uA (assume VIN = 48V). However, the pre-IC leakage current can be very high if EN control has been implemented with a pull-up resistor such as…