Part Number: LMKDB1202 Tool/software: The Mux LMKDB1202 datasheet pin definition does not mention which pin needs how many capacitors and resistors to put.
However, the application circuit file (below) shows that each power group has a 0.1uF/16V capacitor…
Part Number: LMKDB1202
Tool/software:
Hi, TI
I have a question regarding the LOS# operation of the LMKDB1202.
There are two clock inputs, but only one LOS# signal.
In this case, which clock input does the LOS# operate based on, CLKIN0…
Part Number: LMKDB1202 Tool/software: Hi,
Could you please advise how long it takes after enabling SRIS on the clock generator to switch to In2 via the CLKIN_SEL_tri pin (pin 7) of the MUX?
How much delay is required in between? Thank you.
…
Part Number: LMKDB1202 Tool/software: Hi,
For below 2.2ohm, if we use 5% torlerence part, it may cause big impact? or we can use 5% torlerence part to replace 1%? Thanks!
Part Number: LMKDB1202 Tool/software: Hi TI team，
I have recently completed validation of the PCIe interface circuit using the LMK00334RTVRQ1[see attached file LMK00334RTVRQ1_for_TI_review.pdf] ，and it is working correctly。
However, since the LMK00334RTVRQ1…
Part Number: DS160PT801 Other Parts Discussed in Thread: LMKDB1202 Hi,
Currently working on a design that integrates the DS160PT801 into a product.
I am looking at the clocking architecture for it. We will be running PCIe Gen4 through this and would…
Part Number: LMKDB1102 Other Parts Discussed in Thread: LMKDB1202 Tool/software: Dear Sir:
According to datasheet 10.3 Power supply recommendations mention the LMKDB1102 and LMKDB1202 power pin circuit design
If our power pin design as below picture…
Part Number: LMKDB1202EVM Other Parts Discussed in Thread: LMKDB1202 , LMK3H0102 Tool/software: Hi,
We have connect Clk1in P/ N to clk gen EVB 100 MHz, and switch JP1 to H，but output clk1 P / N no output.
OE2#/ OE1#/ - > GND CLKIN_SEL_tri/ ZOUT_SEL…
