Stefano,
The marking is correct. However, the fact that it is difficult to read may still indicate that the device is counterfeit. The same comment applies here as before: if the device was not purchased through authorized distributors it may be counterfeit;…
Part Number: LMP7711 Other Parts Discussed in Thread: LMH1983 , Previously when working on a LMH1983 circuit it was recommended that I use Epson's VG-4231CB 27.0000M-GGCZ3 for my VCXO because of its smaller size and better phase noise performance.
My…
Part Number: LMP7711 Other Parts Discussed in Thread: TINA-TI Hi Team,
Would you advise that as for the input side terminals (+ IN, - IN),
as an absolute value, what kind of lower limit can be detected up to what V can be detected normally?
It refers…
Other Parts Discussed in Thread: LMP7711 , OPA376 I tried to simulate a highside current sense using LMP7711. Because it doesn't worked, I tried a simple test circuit, see attached file.
Selecting "Calculate nodal voltages" gives VF=49.7V and VM1=1…
Other Parts Discussed in Thread: LMP7711 Hello Team,
Could I know if the unity gain bandwidth of LMP7711 is 14MHz or 17MHz?
I cannot decide which one is correct by reading the datasheet.
Thank you very much.
Regards,
Ting
Part Number: LMH1983 Other Parts Discussed in Thread: LMH1981 , LMP7711
Hi,
I have added the LMH1983 and it fails to startup for some reason. There is also an LMH1981 on the PCB connected and it operates fine feeding back a Vsync & Hsync to the LMH1983…
Part Number: LMH1982 Other Parts Discussed in Thread: LMP7711
Hello I have the strange problem reported here https://e2e.ti.com/support/interface/f/138/p/542596/1981841?tisearch=e2e-sitesearch
Did anyone solve it or is it a bug? Thank you.
Hi Joaquin,
As Carlos and Jason mentioned above, there isn't really a way to make the INA138 work well in this application because regardless of how you scale RS, the bias currents are going to dominate your measurement.
If the solutions Jason presented…
